Reviewed by
Cookie Sewell
HyperScale is proudly supported by Squadron.com
Two months after DML released their very nicely done StuG IV "Late model"
they have followed it up with the deluxe version – dubbed "Armor Pro" series by
DML – StuG IV "Early model" kit which adds etched brass and other new parts.
As I noted in May, the Germans produced 1,108 StuG IV vehicles between December
1943 and March 1945 plus 31 conversions from Pzkw. IV tanks; while the
Nibelungenwerke produced the converted Pzkw. IV models , Krupp produced only
StuG IV vehicles after January 1944. The "Early" vehicles used Ausf. H chassis
until July 1944 and then changed over to the "Late" or Ausf. J chassis. The
model now provides parts for one with the H hull and single muffler and exhaust.
DML has done a beautiful job with this kit, and it is another example of the
moldmaker's art. The model comes with separate OVM, hatches, engine access
hatch, and a rough-out 7.5 cm gun. The kit provides two different gun barrels –
a flat top muzzle brake (N13) or the original kit's round one (C21) but both use
DML's now traditional pre-bored muzzle brake (done by sliding a pin through the
sprue runner when molding.)
For ease of painting tiny wheels, DML has really exceeded themselves. Each wheel
set comes molded as one pair with the disk part molded separately; the modeler
can thus paint the tire section black and then camouflage the centers, resulting
in an easy and clean method of getting the wheels painted. A Plus for that one!
Tracks are the new DS plastic gluable vinyl, one section type, so many modelers
will be happy not to wrestle with link-and-length units here. But as I recently
found out from Freddie Leung of DML, they are designed with "slop" built into
them so that they can be "sagged" to show wear on the vehicle. Translation: they
are too long when you get them. The good news is since they are gluable to
styrene plastic a few bare spots and cement mean that you can rig the sag into
them when you install them on the model, so you must take care and plan for it.
The directions are not for beginners, as many steps appear to be assumed, such
as how to assemble the road wheel bogies.
The model now comes with TWO sets of Schuertzen shields – one styrene and one
brass. They account for most of the 90 new parts in the kit, so it is now up to
the modeler whether to use the styrene or brass shields on his model, or simply
leave them off.
Finishing options are provided for six vehicles: 34th Infantry Division, 1945;
unknown on the Gothic Line, Italy 1944; unknown, Eastern Front, Poland 1944; 1st
Panzer Division, Hungary 1945; unknown unit, Lake Balaton, Hungary 1945; 912th
Sturmgescheutz Brigade, Kurland 1945; and unknown unit, Germany, 1945.
Overall this kit is even better than the first one, and should please all StuG
fans.
Highly Recommended.
Thanks to Freddie Leung of DML for the review sample.
Review Copyright © 2005 by Cookie
Sewell
Page Created 10 July, 2005
Last updated 10 July, 2005
Back to HyperScale
Main Page
Back to Reviews
Page